Drag chain Cable General requirements:

1, the laying of the chain cable can not be distorted, that is, not from the cable reel or cable tray to unlock one end of the cable, Drag chain Cable and should be rotated before the reel or cable to expand the cable tray, if necessary, the cable can be expanded or suspended. Cables for this occasion can only be obtained directly from the cable volume.

2. The minimum bending radius of the cable must be noted.

3, the cable must be loosely laid side in tow chain, Drag chain Cable as far as possible separate arrangement, with the partition or into the support of the separation of the aerial block, the gap between the cables in the chain should be at least 10% of the diameter of the cable.

4, the cables in the chain may not be in contact with each other or trapped together.

5, the two points of the cable must be fixed, Drag chain Cable or at least at the moving end of the chain must be fixed. The moving point of a general cable is 20-30 times the distance from the end of the drag chain to the cable diameter.

6, please ensure that the cable in the bending radius of the full movement, that is not forced to move. Drag chain Cable This allows the cables to be relative to each other or to the guide device. After a period of operation, it is best to check the location of the cable. The check must be done after the push is moved.

7, if the chain is broken, Drag chain Cable its cable also needs to be replaced, because excessive stretching caused by damage can not be avoided.