When the equipment unit needs to move back and forth, in order to prevent cable entanglement, wear, pull, hang and scattered, often the cable into the cable towline, the cable to form a protection, and the cable can also be moved back and forth with the towline, which A highly flexible cable that can be moved back and forth with a towline, which is easy to wear, is called a towline cable, usually a towing cable, a tank chain cable.
The towline cable is mainly used in industrial electronic systems, automatic generation lines, storage equipment, robots, fire protection systems, cranes, CNC machine tools and metallurgical industries.
Installation and precautions
From the beginning of the 1980s, industrial automation has allowed the energy supply system to operate over overload, causing the cable to fail to work properly. In some serious cases, the cable "starts" and breaks cause the entire production line to shut down, causing huge economic losses The
Towline cable general requirements:
1, the laying of the towline cable can not be twisted, that is not from the cable reel or cable to unlock the cable at one end, but should first rotate the reel or cable tray to expand the cable, if necessary, the cable can be launched or suspended. The cable used in this case can only be obtained directly from the cable roll.
2, must pay attention to the minimum bending radius of the cable. (The information can be found in the flexible towline cable selection table).
3, the cables must be loosely laid side by side in the towline, separated as far as possible, separated by the septum or into the separation of the stent in the separation of holes in the towline between the cable gap should be at least 10% of the cable diameter.
4, the cable in the towline may not touch each other or trapped together.
5, the two points of the cable must be fixed, or at least the moving end of the towline must be fixed. The distance from the end of the cable should be 20-30 times the diameter of the cable.
6, make sure that the cable is fully moved within the bend radius, ie, it can not be forced to move. So that the cables can be moved relative to each other or with the guide. After a period of operation, it is best to check the location of the cable. The check must be made after the push-pull movement.
7, if the towline break, then the cable also need to be replaced, because the damage caused by excessive stretching can not be avoided.
- High Lift Spiral Cable
- Classification Of High Lift Spiral ...
- Advantages Of Spiral Cable
- High Lift Named Spiral Cable
- Spiral Cable PUR Cables PVC Spiral ...
- Spiral Cable
- Classification Of Spiral Cable
- Coil Spring Cable
- Coil Spring Cable Used
- Car Seven-pin Spiral Cable
- Data Cable Has The Advantages Of Si...
- High Temperature Resistance LOHS Wi...